Stop the Semantic Pollution: Rethinking the Term “Heavy Metals”

Stop the Semantic Pollution: Rethinking the Term “Heavy Metals”

By: Khusnul Yaqin

(For years, I have included John H. Duffus’s seminal work “Heavy Metals—A Meaningless Term?” (2002) in my lectures on aquatic pollution. I discuss it at length with my students. Yet, its critical message rarely seems to resonate. Despite our discussions, students continue to use the term “heavy metals” in their academic writing. This short piece is my modest attempt to ring the alarm and invite reflection on the inaccuracy and misuse of the term.)

The term “heavy metals” has become deeply entrenched across various scientific disciplines—from toxicology, environmental chemistry, and ecotoxicology to policy documents and legal frameworks. It is found in almost every environmental report, thesis, dissertation, research article, and even governmental regulation, as though it were a universally accepted scientific concept. But is it?

A technical report published by the International Union of Pure and Applied Chemistry (IUPAC), authored by John H. Duffus and titled “Heavy Metals—A Meaningless Term?” (2002), offers a stern warning: the term “heavy metals” is not only scientifically unsound but also misleading in both chemical and toxicological contexts.

John H. Duffus is a distinguished figure in the field of chemical toxicology, widely respected for challenging entrenched scientific terminology that lacks precision. As Chair of IUPAC’s Commission on Toxicology, he contributed significantly to the development of rigorous, chemically grounded definitions. He also served at the Edinburgh Centre for Toxicology in Scotland, where his work focused on advancing research and education in the field of toxicology.

The Troubled History of a Misleading Term

The term “heavy metals” has a long and convoluted history. Prior to 1936, it did not appear in scientific literature and was more commonly used in military contexts to denote “heavy weaponry” or metaphorically to describe something powerful or large. Its first recorded scientific usage appeared in the third edition of Inorganic Chemistry by Niels Bjerrum, translated into English in 1936, where he defined heavy metals as elements with a density greater than 7 g/cm³.

That definition, however, never gained universal acceptance. Over time, other scientists proposed alternative definitions based on density thresholds as low as 3.5 or as high as 6 g/cm³. In the decades between the 1960s and 1990s, the term became increasingly popular in environmental and toxicological studies, yet no consistent criteria ever emerged. Some defined it by atomic number, others by atomic weight, and some merely equated it with toxicity—regardless of the element’s actual chemical behavior.

Adding to the confusion, the term came to include semimetals such as arsenic and selenium, which are not metals at all. The widespread inconsistency in defining “heavy metals” has led to serious issues in both scientific discourse and regulatory practice. Recognizing this, scholars like Duffus began calling for the abandonment of the term altogether, citing its lack of chemical and toxicological coherence.

A Vague and Inconsistent Concept

One of the primary issues with “heavy metals” is the absence of any standard, universally agreed-upon definition. In the IUPAC report, Duffus identifies over 20 distinct definitions used across academic literature and regulatory documents. Some rely on density, others on atomic number or atomic mass, and still others use the term as a shorthand for toxicity—an imprecise and often incorrect assumption.

For example, elements like lead, cadmium, and mercury are commonly labeled as heavy metals due to their known toxic effects. Yet essential elements such as copper, zinc, calcium, and even magnesium are sometimes included as well. Some classifications inexplicably list non-metallic elements, like arsenic and selenium, as “heavy metals” based solely on their perceived danger.

The result is conceptual chaos. Without a shared definition, the term loses any meaningful scientific utility and becomes an obstacle to clear communication—especially in policy, education, and environmental risk assessment.

Heavy ≠ Toxic

A fundamental misconception underlying the term is the assumption that “heaviness” implies toxicity. This is not only scientifically inaccurate, but also dangerously misleading.

Metal toxicity is not determined by density or atomic mass. Instead, it depends on factors such as chemical speciation, oxidation state, bioavailability, and dosage. Chromium in its metallic form is non-toxic and used safely in medical implants, whereas hexavalent chromium (Cr⁶⁺) is a well-documented carcinogen. Iron and copper are essential for biological systems but become harmful in excess. Bismuth, despite its high density, is relatively benign.

The term “heavy metals” fails to distinguish between a metal’s pure form and its various chemical compounds—each with distinct physicochemical and biological properties. It also ignores the fact that different species interact with metals in different ways, further complicating blanket toxicological assessments.

Implications for Academia and Policy

In Indonesia, the term “logam berat” (heavy metals) is deeply embedded in academic curricula and scientific literature. Many educators, researchers, and students continue to use it without questioning its validity. Even regulatory documents employ it, often without listing the specific elements in question.

This creates a dangerous disconnect between science and policy. For regulation to be effective and evidence-based, its terminology must be precise. As the IUPAC report emphasizes, “Understanding bioavailability is the key to the assessment of the potential toxicity of metallic elements and their compounds… any classification of the metallic elements to be used in scientifically based legislation must itself be based on the periodic table.” By using more accurate and precise terminology, we can ensure that our policies are based on the best available scientific evidence, leading to more effective and targeted interventions.

In short, scientific classification should derive from the elemental properties described in the periodic table—not from vague categories like “heavy.”

Toward a More Accurate Scientific Language

Duffus and colleagues propose alternative classification schemes based on chemical behavior, such as periodic table groupings (s-, p-, d-, and f-blocks) or Lewis acid characteristics (Class A—hard acids, Class B—soft acids, and borderline types). These approaches not only allow for more precise predictions of toxicity, environmental mobility, and biological interactions, but also open up new avenues for scientific discovery and understanding.

For instance, soft metal ions like mercury and cadmium tend to bind strongly with sulfur-containing ligands, disrupting protein function. In contrast, hard ions like calcium or magnesium prefer oxygen ligands and are less likely to cause harm in biological systems.

Science cannot function on imprecise language. Clinging to the term “heavy metals” perpetuates confusion, obstructs research, and undermines sound policy-making. It is a form of semantic pollution that leads to real-world consequences—including misguided risk assessments and ineffective environmental interventions. The need for precision in our scientific terminology is not just a matter of academic debate, but a crucial aspect of our ability to understand and address environmental and toxicological challenges.

We do not lump all carbon compounds under the label “carbon”—we differentiate methane from carbon dioxide, and benzene from amino acids—because their behaviours and hazards are fundamentally different. Similarly, we should not group all metal-containing compounds under the vague label of “heavy metals.”

Conclusion

The term “heavy metals” may be habitual, but habit is no excuse for scientific inaccuracy. Duffus’s work offers a clear directive: the term is outdated, unscientific, and counterproductive. It is time to retire it and adopt more chemically precise terminology.

Let us, as scientists, educators, and policymakers, commit to greater clarity and integrity in our language. The first step is simple but powerful: stop using “heavy metals” in scientific writing.

Tamalanrea Mas, at the end of Ramadan, March 29, 2025